Cardboard Cable Car Model With Recycled Materials, Working Model 250rpm Electric Motor and Basic Slide Switch ON-OFF-ON (School Science Project)

You can show this cardboard model as an enjoyable school project. At the same time learn the working principle of a cable car by building it.

Difficulté

Easy Facile

Durée

2 hour(s) heure(s)

Catégories

Électronique, Énergie

Coût

3.00 USD ($)

Cardboard Cable Car Model, cardboard model, cable car, rcycled material, working model, cable car model Cardboard_Cable_Car_Model_With_Recycled_Materials__Working_Model_250rpm_Electric_Motor_and_Basic_Slide_Switch_ON-OFF-ON__School_Science_Project__maxresdefault.jpg Technique

Introduction

You can show this cardboard model as an enjoyable school project. At the same time learn the working principle of a cable car by building it.

Youtube

1. 
2. 
3. 
4. 
5. 
6. 

Matériaux

• 1pcs 25*35cm 5mm Cardboard for project Ground

• 8pcs popsicle stick (15cm)

• 2pcs Plastic Pulley Wheel (Recycled from old CD/DVD burner)

• 1pcs DC BO Motor (6V)

• 7x4x3cm cardboard Block (Stacked 6pcs 4*7cm cardboard)

• Plastic Bottle Cap

• 4pcs Match

• 1pcs Battery Holder

• 1pcs DPDT On-Off-On Slide Switch

• Passengers (Optional)

• Nylon yarn

• 1pcs thin nail

Outils

• soldering iron

• Cutter

• Glue

Étape 1 - Mounting Pulley Wheel on Motor Shaft

You can check all steps on video briefly or follow below steps.

• Mount plastic pulley wheel onto DC motor shaft and glue on it.

Étape 2 - Glue Popsicle Stick for Pulley Holder

Glue the popsicle sticks on top of each other.

1 set of 4 sticks will be glued on top of each other.

2 sets of 2 sticks will be glued on top of each other.

en none 0 Draft