Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

...and now actually attaching the strips. I "clamp" them on using some painters tape. +
Finally I cut in a dado to the top and bottom piece to eventually insert a vertical partition. I use a router and then square up the cut using a chisel. +
Here I'm making the doors fro the case out of 1/4" maple plywood. They don't have any handles, just a little negative space for a finger to grab. +
I live the strips a little wider than 3/4 of an inch so that they are slightly proud of the plywood. Then I trim them flush using a router. +
I started with a full sheet of Maple plywood. I broke it down into manageable chunks using my track saw. +
Now that the rough pieces are created, I f … Now that the rough pieces are created, I find tune everything to finished dimensions and cut in some joinery. Here I'm making miters on the edges of all of the case pieces. On the second picture I'm cutting in rabbets to the backs of the pieces so that I can eventually inset the back panel.hat I can eventually inset the back panel. +
Then I cut a few grooves into the front of all of the pieces to hold some sliding doors. +
Then I cut to the rough dimensions on my table saw. +
Then I glued and assembled everything. Lots of assembly +
Then I sanded everything. +
Then I varnished everything +
Then with all of the pieces to their proper dimensions I cut in some joinery, and some dados to hold the shelves. +
This [https://www.youtube.com/watch?v=TjflF2hCdrQ youtube video] takes you through the design and build process. It includes detailed builds, design-talk, 3D modeling, and more. Don't forget to subscribe! +
To cover up the plywood lines, I ripped some thin strips of maple hardwood. Here I'm applying the glue to adhere the strips. +
With every thing made, i assembled the case. I used a couple dominoes to make assembly easier and provide a bit of reinforcement. +
With the cabinet out of the way I turned my attention to the frame. First I milled and cut out blanks for all of the pieces. These are made from Walnut hardwood. +
You can see I'm a big proponent of marking the hell out of things. Trying to avoid mistakes...thought I still make them. +