Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- After the cycle, check your parts. If they're still dirty, run another cycle. Some stubborn deposits might need a second or third cleaning. +
- Apply a light coat of oil to prevent rust, especially on bare metal parts. Reassemble everything according to your equipment manual. +
- Fill the cleaner with the right solution. … Fill the cleaner with the right solution. For oily, greasy excavator parts, use a solution made for metals. Follow the mixing instructions on the package. Heat the solution to about 140°F (60°C) for best results. Most ultrasonic cleaners have built-in heaters.ultrasonic cleaners have built-in heaters. +
- Put your parts in the cleaning basket care … Put your parts in the cleaning basket carefully. Follow these tips: * Don't stack parts on top of each other * Make sure all surfaces can touch the cleaning solution * Position hollow parts so air bubbles can escape * Keep any rubber seals above the solution if possibleubber seals above the solution if possible +
- Rinse your parts thoroughly with clean water. Distilled water works best for the final rinse. Dry the parts completely. You can use: * Compressed air * A warm oven (170°F/75°C) * Clean, lint-free towels +
- Set the timer for 10-15 minutes to start. Some really dirty parts might need up to 30 minutes. Don't open the lid during cleaning - this reduces the effectiveness. +
- Take apart the components following your equipment manual. Rinse off loose dirt with water or use compressed air to blow it away. Check what materials your parts are made from. Most excavator parts are steel or iron and clean well in ultrasonic cleaners. +
Français
English
Deutsch
Español
Italiano
Português