Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.
Liste de résultats
- Attach the cabinet to the rope +
- Cut away 4pcs Match heads. Prepare 2pcs 4x3cm 3mm cardboard and glue Matches on the corners. Don't forget the Passengers +
- Cut ~30º Angle Holder for Cable Car Container +
- Drill a hole on slingshot shaped holder for plastic pulley. +
- Glue 250rpm 3-6V DC motor onto cardboard block. +
- Glue cardboard block onto base left side. +
- Glue pulley holder slingshot onto plastic bottle cap to increase height. Glue pulley holder slingshot onto right side of base. +
- Glue the angled cabin hanger onto the cabin +
- Glue the popsicle sticks on top of each other. 1 set of 4 sticks will be glued on top of each other. 2 sets of 2 sticks will be glued on top of each other. +
- Glue the popsicle sticks together in the form of a slingshot, keeping the group of 4 in the middle. +
- Knot the rubber band and cut it. +
- Mount plastic pulley wheel with a nail between slingshot arms. +
- Solder the cables coming from the middle pins of the slide switch to the motor pins. +
- Solder the cables from the other ends to the pins on the battery holder. +
- Solder the wires onto the 6 pin slide switch for forward and reverse movement. +
- Start the cable car by moving the switch back and forth, have fun 👏👏👏👏 +
- Tie the rubber band together with nylon thread. +
- Tie the yarn between the pulleys by adjusting the tension with the rubber band. +
- You can check all steps on video briefly or follow below steps. • Mount plastic pulley wheel onto DC motor shaft and glue on it. +
Français
English
Deutsch
Español
Italiano
Português