Rechercher dans les propriétés de la page

Cette page fournit une interface de navigation pour trouver toutes les valeurs d’une propriété et une page donnée. D’autres interfaces de recherche disponibles incluent la recherche de propriété, et le constructeur de requête ask.

Liste de résultats

• # Cut off the middle leg of the Transisto … # Cut off the middle leg of the Transistor SS9018HBU TO-92, and plug it into the socket left 1st and 3rd # Plug in the first capacitor into the socket right, with + in the 1st and - in the 4th # Plug in an audio cable to an amplified speaker, or laptop # Connect the battery FINISHED! OFF YOU GO, AND HAVE FUN WITH YOUR LITTLE SYNTH!!! Remember. If you change the capacitor size, you will have different pitch ranges.
  u will have different pitch ranges. <br/>   +
• # Cut the overlapping part of the leg shown in the picture # Bend the piece like an wide U, and put it into the place at the potentiomenter # Solder the U to bridge the channels   +
• # Take each basic component and put it on … # Take each basic component and put it onto the marked place (You might need to use some tape to hold the elements in place) # Check, if + of LED is on the shown side # Solder each part on the board...DO NOT CUT THE LEGS, WE NEED IT!!! # Bend the legs like it is shown in the second image
  like it is shown in the second image <br/>   +
• # Take your time and look at the schematic. Start with + and run through the different ways till you end back to - pole # The second image shows you the pins you are going to use # Go and mark all pins on your board   +
• * Solder the wire as shown * Using this prototype board, you will need to connect wires to the soldered elements directly * Compare the schematic with the photos to see which pins need to be connected * Be careful not to bridge other pins accidentally   +
• * Solder the wire as shown * Using this p … * Solder the wire as shown * Using this prototype board, you will need to connect wires to the soldered elements directly * Compare the schematic with the photos to see which pins need to be connected * Be careful not to bridge other pins accidentally
  ot to bridge other pins accidentally <br/>   +
• Here you need to take of a bigger piece of … Here you need to take of a bigger piece of the wires isolation, so you can then use it to get to the jack sockets ground pin on the other side. Check the second image * Solder the wire as shown * Using this prototype board, you will need to connect wires to the soldered elements directly * Compare the schematic with the photos to see which pins need to be connected * Be careful not to bridge other pins accidentallyeful not to bridge other pins accidentally  +
• Now use the legs of the basic soldered components, and connect it like shown in the image  +