Recherche par propriété

Cette page fournit une simple interface de navigation pour trouver des entités décrites par une propriété et une valeur nommée. D’autres interfaces de recherche disponibles comprennent la page recherche de propriété, et le constructeur de requêtes ask.

Une liste de toutes les pages qui ont la propriété « Step Content » avec la valeur « For the circuit you will need a lithium coin cell, a vibrating motor and a slide switch. First test your vibrating motor by connecting the negative wire (usually black) with the negative side of the battery, and the positive wire (red) with the positive side of the battery. It should start to vibrate. Insert the switch into the back hole of the 3D printed holder and stick into place using a glue gun. Take the vibrating motor and mount it on the back left corner of the 3D printed holder with the wires exiting towards where the battery will sit. Connect the positive wire (red) from the vibrating motor to one of the switch's middle pins. Attach the wire to the pin by soldering. The negative wire (black) from the vibrating motor needs to touch the negative side of the battery. It can be held in place using a small piece of Sellotape. Insert the battery into the holder. It may need a small piece of folded card to sit under it to make sure it sits high enough so that the top surface (positive side) of the battery touches the lower pins of the switch. In summary: +ve vibrator connection to middle pin of switch (soldered) -ve vibrator connection to -ve side of battery (held by tape) Battery sat in holder with +ve side up, raised high enough to touch bottom pin of the switch ». Puisqu’il n’y a que quelques résultats, les valeurs proches sont également affichées.

Affichage de 1 résultat à partir du n°1.

Voir (200 précédentes | 200 suivantes) (20 | 50 | 100 | 250 | 500).

Propriété : Valeur :

Liste de résultats

Buzzing Bee Circuit + (For the circuit you will need a lithium co … For the circuit you will need a lithium coin cell, a vibrating motor and a slide switch. First test your vibrating motor by connecting the negative wire (usually black) with the negative side of the battery, and the positive wire (red) with the positive side of the battery. It should start to vibrate. Insert the switch into the back hole of the 3D printed holder and stick into place using a glue gun. Take the vibrating motor and mount it on the back left corner of the 3D printed holder with the wires exiting towards where the battery will sit. Connect the positive wire (red) from the vibrating motor to one of the switch's middle pins. Attach the wire to the pin by soldering. The negative wire (black) from the vibrating motor needs to touch the negative side of the battery. It can be held in place using a small piece of Sellotape. Insert the battery into the holder. It may need a small piece of folded card to sit under it to make sure it sits high enough so that the top surface (positive side) of the battery touches the lower pins of the switch. In summary: +ve vibrator connection to middle pin of switch (soldered) -ve vibrator connection to -ve side of battery (held by tape) Battery sat in holder with +ve side up, raised high enough to touch bottom pin of the switchh enough to touch bottom pin of the switch)