Voir la source de Plastic-Waste Pavement

{{ {{tntn|Tuto Details}}
|SourceLanguage=none
|Language=en
|IsTranslation=0
|Type=Creation
|Area=Decoration, Furniture, Recycling and Upcycling
|Tags=Recycle, Plastic, Waste, Pavement, Outside, Low-Tech, Sustainable, Autonomy
|Description=Recycle the plastic waste into pavement blocks to:
•	Move and work in the garden during the rainy season,
•	Remove trash from the nature,
•	Reduce the burning of plastics and,
•	Raise awareness about the waste issue and hope to influence the local communities toward a wasteless future.
|Difficulty=Very easy
|Cost=0
|Currency=EUR (€)
|Duration=30
|Duration-type=minute(s)
|Licences=Attribution (CC BY)
}}
{{ {{tntn|Introduction}}
|Introduction== Acknowledgements =
In Homa Bay, Kenya, as in most place we have been in Africa, there is no proper waste management solution accessible to local communities. As a result, we see litter -especially plastic waste- everywhere. The most commonly-adopted alternative is to burn the plastic waste. But burning releases toxic chemicals in the atmosphere and are, thus, a danger for the people doing it (not talking about the harm for soil, water, air, fauna, flora…). Thus, around the garden, we find a lot of plastic waste (plastic bags, pieces of recipients, worn out shoes, milk packs…). We also find a lot of empty cement bags and dirt due to recent construction work on the permaculture school and site latrines. Moreover, during the rainy season, the garden here gets muddy and it becomes difficult to move and work in the garden.

= Our solution and its expectable benefits =
Recycle the plastic waste into pavement blocks to:

·      Move and work in the garden during the rainy season,

·      Remove trash from the nature,

·      Reduce the burning of plastics and,

·      Raise awareness about the waste issue and hope to influence the local communities toward a wasteless future.
}}
{{ {{tntn|Materials}}
|Material=* Parts:
** NA (we collect them)
* Consumables:
** Soap (for the rest, we collect them)
|Tools=*Tools:
**(1) Wheelbarrow,
**(1) Shovel and,
**(1) Knife;
}}
{{ {{tntn|Separator}}}}
{{ {{tntn|Tuto Step}}
|Step_Picture_00=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic006.jpg
|Step_Title=How?
|Step_Content=Refer to the pictures available in the gallery. Proceed as follows to build you own Plastic-Waste Pavement.

== Required Conditions ==
*Team:
**One is enough (more is very much appreciated)
*Required skills:
**None
*Duration:
**30 minutes (per unit)
*Preliminary requirements:
**NA
}}
{{ {{tntn|Tuto Step}}
|Step_Picture_00=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic000.jpg
|Step_Picture_01=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic001.jpg
|Step_Title=Collect waste:
|Step_Content=#Move around with bags and wheelbarrow to collect waste,
#If necessary, brake down the biggest pieces of waste into smaller pieces to make it easier to transport;

{{Info|Also, brake down the biggest pieces to make it easier to fill bags in next steps.}}{{Info|Feel free to sing along as this task is time-consuming and sometimes quite frustrating (with our friend Felix, we created our own dedicated song: “trash everywhere”}}
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Collect empty bags,
|Step_Content={{Info|We used the cement bags available on the compound.}}
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Define the location where you want to install the Plastic-Waste Pavement,
|Step_Content=
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Carry the collected waste and empty bags to the location (or close to location),
|Step_Content=
}}
{{ {{tntn|Tuto Step}}
|Step_Title=If dirt is available at location, proceed with next step. Else:
|Step_Content={{Dont|Avoid nutrient-rich soil such as humus or compost, prefer inert dirt.}}
#Empty the waste from the wheelbarrow at location,
#Use the wheel barrow to collect dirt,
#Carry the collected dirt to location (or close to location);
}}
{{ {{tntn|Tuto Step}}
|Step_Picture_00=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic002.jpg
|Step_Picture_01=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic003.jpg
|Step_Title=Fill the bags with trash:
|Step_Content={{Dont|Avoid nutrient-rich soil such as humus or compost, prefer inert dirt.}}
#Add a layer of trash,
#Use a shovel to add a layer of dirt
#Lift the bag and release it on the ground to stuff the waste and dirt in the bag,
#Repeat the steps above until the bag is full;{{Info|Three to four shovel equivalents should be OK.}}{{Info|The mix will get denser and denser.}}{{Info|The bag will get heavier and heavier.}}{{Info|We estimate that we stuff 50% of waste and 50% of dirt.}}
}}
{{ {{tntn|Tuto Step}}
|Step_Title=If needed, use a knife to draw holes in the upper part of the filled bag,
|Step_Content=
}}
{{ {{tntn|Tuto Step}}
|Step_Picture_00=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic004.jpg
|Step_Title=Use a rope and go through the holes on the upper part of the filled bag to close the filled bag,
|Step_Content={{Info|Ideally, use a rope from step 1.}}
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Tie the rope to secure the Plastic-Waste Pavement,
|Step_Content=
}}
{{ {{tntn|Tuto Step}}
|Step_Title=
|Step_Content=
}}
{{ {{tntn|Tuto Step}}
|Step_Title=If needed, use a knife to cut the loose part of the rope from the Plastic-Waste Pavement,
|Step_Content={{Info||[https://permacultureprinciples.com/principles/_6/ Waste  not, want not!]
|}}
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Walk and/or jump on the Plastic-Waste Pavement to give it the shape you want,
|Step_Content={{Info|We wanted it to have a pavement shape, like a big flat brick.}}
}}
{{ {{tntn|Tuto Step}}
|Step_Picture_00=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic005.jpg
|Step_Picture_01=Plastic-Waste_Pavement_SIY-TS-20-001-PlasticWastePavement-Pic006.jpg
|Step_Title=Install the pavement,
|Step_Content=
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Use soap to wash your hands.
|Step_Content='''Good job!'''
}}
{{ {{tntn|Notes}}
|Notes=== FAQ & Troubleshooting? ==

=== I do not like collecting trash, what can I do? ===
We suggest an individual and collective approach to that one: install dust bins and influence the community to use those dust bins! Collection should be much easier 😊

Other suggestion: team-up! The greater the number, the greater the fun.

=== The bag I used is not sturdy enough: it breaks OR content comes out of the bag; what can I do? ===
The easiest is to install the defect bag upside down in a “new” bag (without trash in it) and close the bag. Why upside down? If the end of one bag opens, content will remain inside the assembly; if both ends are on the same side, content might leak.

= Go further… =
Please share with us with your remarks, comments, improvements, achievements, etc. and let’s clean this place up; let’s not forget: Reduce – Reuse – Recycle – Repair, 4R that makes us (and the planet) happy (or not too unhappy).

Read about our volunteering in Homa Bay, Kenya: will come soon 😊

Learn more about our projects: https://sustainable-autonomy.weebly.com/

Follow us: Twitter logo => https://twitter.com/Sustainomy/
}}
{{ {{tntn|Tuto Status}}}}