Voir la source de Open Workshop Setup

{{ {{tntn|Tuto Details}}
|Main_Picture=Open_Workshop_Setup_OpenWorkshopSetup-new-15.jpg
|Licences=Attribution-ShareAlike (CC BY-SA)
|Description=Create a simple worspace setup to manage and organise your tools and materials
|Area=Electronics, Machines and Tools, Recycling and Upcycling
|Type=Creation
|Difficulty=Easy
|Duration=8
|Duration-type=hour(s)
|Cost=100
|Currency=USD ($)
|Tags=Workshop, Tools, Materials, Open Source Hardware, Management
|SourceLanguage=none
|Language=en
|IsTranslation=0
}}
{{ {{tntn|Introduction}}
|Introduction=Creating a organised workshop is key for your active work on projects. 

So we came up with a simple and cheap way of doing it, the more material you upcycle to build it, the more you can reduce the costs.
}}
{{ {{tntn|Materials}}
|Step_Picture_00=Open_Workshop_Setup_OpenWorkshopSetup-new-7.jpg
|Step_Picture_01=Open_Workshop_Setup_OpenWorkshopSetup-new-4.jpg
|Step_Picture_02=Open_Workshop_Setup_OpenWorkshopSetup-new-1.jpg
|Material=* 2x plywood (90x60cm, 90x120cm)
* nails (100, 60, 40, 25 mm)
* timber (for the box) + leftover plywood sheets
* long timber (120x7cm)
* boxes
* water bottles (1.0 & 0.5 l)
* solid wooden table (120x70x90cm)
|Tools=* hammer
* saw
* sissors
* tape measure 
* water level
* square
* sandpaper
* documentation camera/smartphone cam
}}
{{ {{tntn|Separator}}}}
{{ {{tntn|Tuto Step}}
|Step_Title=Space selection & preparation
|Step_Content=* You need a space where you can work, so at least 8x bigger than your original workshop spot
* use a corner of the room (about 2.0x1.0m Space minimum)
* keep lights and accessebillity in mind
* kreate an overview of tools and materials you have
* start looking for a good sized plywood for your tools (big) and your small materials (small)
* use a solid table as base for the construction (at least 90cm high and 70cm deep)
* have a powerplug close to it
* cut the wood sheets
|Step_Picture_00=Open_Workshop_Setup_Workspace-sketch.jpg
}}
{{ {{tntn|Tuto Step}}
|Step_Title=prepare tools & materials
|Step_Content=* sort materials and tools by type and usage
* cut the bottles to fill with materials (screws, bolts, nuts, washers, hooks, rivets etc.)
* place the tools in order on the ground to the sheet (try different setups)
* draw a fine line with a pencil around the tools
* cut the parts for the box and the skrewdriver board and add it to the wall setup
* nail everything to the board and remove the tools
|Step_Picture_00=Open_Workshop_Setup_OpenWorkshopSetup-new-9.jpg
|Step_Picture_01=Open_Workshop_Setup_OpenWorkshopSetup-new-10.jpg
|Step_Picture_02=Open_Workshop_Setup_OpenWorkshopSetup-new-6.jpg
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Fix the boards to the wall
|Step_Content=* fix the tool board
* fix the material board
* fix the timber board for extra space (allowing it to remove the table still holding everything in place)
*
}}
{{ {{tntn|Notes}}
|Notes=
}}
{{ {{tntn|Tuto Status}}
|Complete=Draft
}}