Traduire

Traduire en Deutsch

Traduction de la page wiki Open Workshop Setup depuis anglais (en).

Cet outil ne fonctionne pas sans JavaScript. JavaScript est désactivé ou n'a pas pu s'exécuter, ou cet explorateur ne le prend pas en charge.

Tous
Non traduit
Désuets
Traduit
Non relu
...
- Messages facultatifs

Translations:Open Workshop Setup/Page display title/de

Open Workshop Setup

Vous devez obtenir les droits de traduction pour traduire des messages.Obtenir la permission

Chargement en cours…

* 2x plywood (90x60cm, 90x120cm) * nails (100, 60, 40, 25 mm) * timber (for the box) + leftover plywood sheets * long timber (120x7cm) * boxes * water bottles (1.0 & 0.5 l) * solid wooden table (120x70x90cm)‎

Modifier

* hammer * saw * sissors * tape measure * water level * square * sandpaper * documentation camera/smartphone cam‎

Modifier

Space selection & preparation‎

Modifier

* You need a space where you can work, so at least 8x bigger than your original workshop spot * use a corner of the room (about 2.0x1.0m Space minimum) * keep lights and accessebillity in mind * kreate an overview of tools and materials you have * start looking for a good sized plywood for your tools (big) and your small materials (small) * use a solid table as base for the construction (at least 90cm high and 70cm deep) * have a powerplug close to it * cut the wood sheets‎

Modifier

prepare tools & materials‎

Modifier

* sort materials and tools by type and usage * cut the bottles to fill with materials (screws, bolts, nuts, washers, hooks, rivets etc.) * place the tools in order on the ground to the sheet (try different setups) * draw a fine line with a pencil around the tools * cut the parts for the box and the skrewdriver board and add it to the wall setup * nail everything to the board and remove the tools‎

Modifier

Fix the boards to the wall‎

Modifier

* nail the board to the wall. (you can also use screws)‎

Modifier

* Build up some boxes for materials like markers.‎

Modifier

* Draw the shapes of the materials and tools for easy identification after use. * fix the timber board under the board, right above the table.‎

Modifier

Fix tools and materials to the boards and finish up‎

Modifier

* Tools and materials should be fixed based on there shapes.‎