Voir la source de Is it possible to replace the WR3 module with an ESP-12 module

{{Tuto Details
|Description=<translate>In this Documentation I am showing what I was able to find out about the MiBoxer WL5 5 in 1 WiFi RGB+CCT Controller.</translate>
|Area=Electronics
|Type=Creation
|Difficulty=Medium
|Duration=20
|Duration-type=minute(s)
|Cost=15
|Currency=EUR (€)
}}
{{Introduction
|Introduction=<translate>I ordered a RGB+CCT controller online and to my surprise the device came with a new Tuya WiFi module instead of an ESP module.

Now I am trying to swap the WR3 Tuya WiFi module with an ESP-12f module.


In the following steps I will display my findings.</translate>
}}
{{Materials}}
{{Tuto Step
|Step_Title=<translate>The PCB on which the Tuya WR3 module is soldered on.</translate>
|Step_Content=<translate>I desoldered the WR3 module to check the connections with my meter and also used a lamp to expose the traces.</translate>
|Step_Picture_00=Is_it_possible_to_replace_the_WR3_module_with_an_ESP-12_module_1_WiFi_module.jpg
}}
{{Tuto Step
|Step_Title=<translate>The Top and bottom side of the whole PCB.</translate>
|Step_Content=<translate>This shows the top and bottom side</translate>
|Step_Picture_00=Is_it_possible_to_replace_the_WR3_module_with_an_ESP-12_module_1_WiFi_module_top_bottom.jpg
}}
{{Notes
|Notes=<translate></translate>
}}
{{PageLang
|Language=en
|SourceLanguage=none
|IsTranslation=0
}}
{{Tuto Status
|Complete=Draft
}}