Voir la source de Communication Dish

{{ {{tntn|Tuto Details}}
|SourceLanguage=none
|Language=en-gb
|IsTranslation=0
|Main_Picture=Communication_Dish_Picture1.jpg
|Licences=Attribution (CC BY)
|Description=The communication dish is meant to help in amplifying signals for gadgets where the signal is not so strong.
|Area=Machines and Tools, Recycling and Upcycling
|Type=Creation
|Difficulty=Medium
|Duration=1
|Duration-type=day(s)
|Cost=30
|Currency=USD ($)
|Tags=phone dish, communication dish, amplifyer
}}
{{ {{tntn|Introduction}}
|Introduction=
}}
{{ {{tntn|Materials}}
|Step_Picture_00=Communication_Dish_Picture5.jpg
|Material= Plywood

 Cable ties

 Ropes

 Spray paints
|Tools=Chain

Jigswa

Elecronic Saw

Table

Pliers

Tape measure

Spirit Level

Pensil
}}
{{ {{tntn|Separator}}}}
{{ {{tntn|Tuto Step}}
|Step_Title=Measuring and Sketching
|Step_Content=Measure and sketch the correct measurements required to make the dish on the plywood.(The measurement should be precisely done as this affects how the dish will turn out)
|Step_Picture_00=Communication_Dish_Picture3.jpg
|Step_Picture_01=Communication_Dish_Picture4.jpg
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Cutting and subdividing sections
|Step_Content=After you are done with the measurements on the plywood, check to ensure that this is correctly done

 Begin by cutting the different parts of the plywood using a jigsaw.(Note, ensure that this is precisely done.
|Step_Picture_00=Communication_Dish_Picture2.jpg
|Step_Picture_01=Communication_Dish_Picture6.jpg
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Drilling holes on the plywood
|Step_Content= Drill holes into specific points on the plywood which will later be used for fixing the mesh wire

 Using cable ties, join the plywood pieces together to form the base of the dish
}}
{{ {{tntn|Tuto Step}}
|Step_Title=
|Step_Content=Using the cable ties, join your mesh wire to the plywood background
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Cutting and subdividing sections
|Step_Content=After you are done with the measurements on the plywood, check to ensure that this is correctly done

 Begin by cutting the different parts of the plywood using a jigsaw.(Note, ensure that this is precisely done.
|Step_Picture_00=Communication_Dish_Picture2.jpg
|Step_Picture_01=Communication_Dish_Picture6.jpg
}}
{{ {{tntn|Tuto Step}}
|Step_Title=Drilling holes on the plywood
|Step_Content= Drill holes into specific points on the plywood which will later be used for fixing the mesh wire

 Using cable ties, join the plywood pieces together to form the base of the dish
}}
{{ {{tntn|Tuto Step}}
|Step_Title=
|Step_Content=Using the cable ties, join your mesh wire to the plywood background
|Step_Picture_00=Communication_Dish_Picture7.jpg
}}
{{ {{tntn|Notes}}
|Notes=
}}
{{ {{tntn|Tuto Status}}
|Complete=Draft
}}