]> 2026-06-15T03:32:30+02:00 Entryway catch-all table 0 en Decoration Furniture House Published 50 USD ($) We needed a place to organize our stuff where we walk into our house. This entryway catch-all sideboard is the first, of a few, that will help solve our problem. Medium 5 hour(s) false en Attribution (CC BY) Entry way catch all table cabinet Final.jpg * Check out my projects on my website : http://www.foureyesfurniture.com/ none I started with a full sheet of Maple plywood. I broke it down into manageable chunks using my track saw. Then I cut to the rough dimensions on my table saw. To cover up the plywood lines, I ripped some thin strips of maple hardwood. Here I'm applying the glue to adhere the strips. ...and now actually attaching the strips. I "clamp" them on using some painters tape. I live the strips a little wider than 3/4 of an inch so that they are slightly proud of the plywood. Then I trim them flush using a router. Now that the rough pieces are created, I find tune everything to finished dimensions and cut in some joinery. Here I'm making miters on the edges of all of the case pieces. On the second picture I'm cutting in rabbets to the backs of the pieces so that I can eventually inset the back panel. Then I cut a few grooves into the front of all of the pieces to hold some sliding doors. Finally I cut in a dado to the top and bottom piece to eventually insert a vertical partition. I use a router and then square up the cut using a chisel. With every thing made, i assembled the case. I used a couple dominoes to make assembly easier and provide a bit of reinforcement. Here I'm making the doors fro the case out of 1/4" maple plywood. They don't have any handles, just a little negative space for a finger to grab. With the cabinet out of the way I turned my attention to the frame. First I milled and cut out blanks for all of the pieces. These are made from Walnut hardwood. You can see I'm a big proponent of marking the hell out of things. Trying to avoid mistakes...thought I still make them. Then with all of the pieces to their proper dimensions I cut in some joinery, and some dados to hold the shelves. Then I glued and assembled everything. Lots of assembly Then I sanded everything. Then I varnished everything This [https://www.youtube.com/watch?v=TjflF2hCdrQ youtube video] takes you through the design and build process. It includes detailed builds, design-talk, 3D modeling, and more. Don't forget to subscribe! Cut to the rough dimensions Cover up the plywood lines Attaching the strips Trim the strips using a router. Find tune everything Cut a few grooves Cut in a dado to the top and bottom piece Case assembly Make the doors Frame Cutting a long taper on the bandsaw. Joinery Glue and assemble everything Sand everything Finished Tada! Creation 2019-12-09T10:32:19Z 2458826.9391088 Entryway catch-all table 0 0 0