Electronic textile bag

Electronic textile bag.

Par Gameferre2003

10 étapes

Aucune étape

Sommaire

Accueil 1. Cut 4 round textile patches 2. Prepare the Led patch 3. Prepare the speaker and the mini vibrating motor patches 4. Prepare the photoresistor patch 5. Choose the design of your e-textile bag 6. Sew the top of the snap buttons on to the textile bag 7. Sew the conductive thread to the textile bag 8. Solder jumper wires to the safety pins 9. Sew the Arduino board to the inside of the textile bag 10. Cover all safety pins with some tape to avoid short circuits and unwanted connections

Matériaux & outils nécessaires

Matériaux

<translate> * conductive thread (about 13 meters) * 2mm thick textile (or thinner) * 1 x Led * 1 x 8 ohm speaker * 1 x mini vibrating motor * 1 x photoresistor * 1 x textile bag * 1 x Arduino board + power cable * 6 x jumper wires * 6 x small safety pins (around 4 cm long) * 9 x metal snap buttons (make sure they are not coated and are conductive) * 1 x 250 ohm resistor (or similar) * electric wire (about 1 meter)</translate>

Outils

<translate> * 1 x soldering iron * Pc with Arduino IDE installed * needles and thread</translate>